San Switch 4/32 Port Side Led Patterns During Normal Operation - HP AA979A - StorageWorks SAN Switch 2/8V Installation Manual

Table 17 describes port side LEDs.
Table 17

SAN Switch 4/32 port side LED patterns during normal operation

LED name LED color
Power Status No light
Steady green
System Status No light
Steady green
Steady amber (for
more than five
seconds)
Flashing
amber/green
Ethernet No light
Speed
Steady green
Ethernet Link No light
Steady amber
Flashing amber/no
light
72 Managing SAN switches
Status of hardware
System is off or there is an internal
power supply failure.
System is on and power supplies
are functioning properly.
System is off, boot is not complete,
or boot failed.
System is on and power supplies
are functioning properly.
Boot failed, the system is faulty.
Attention is required. A number of
variables can cause this status
including a single power supply
failure, a fan failure, or one or
more environmental ranges has
exceeded.
Port speed is 10 Mb/sec.
Port speed is 100 Mb/sec.
There is no link.
There is a link.
There is link activity (traffic).
Recommended action
Verify that system is on. If the system is
on, the unit is faulty.
Contact HP Technical Support.
No action required.
Verify that system is on and has
completed booting.
No action required.
Perform the following steps:
1. Connect a serial cable to the
system.
2.
Reboot the system.
3. Check the failure indicated on the
system console.
4. Contact HP Technical Support.
Check the management interface and
the error log for details on the cause of
status.
Contact HP Technical Support if
required.
No action required.
No action required.
Verify that the Ethernet cable is
connected correctly.
No action required.
No action required.