Brocade Communications Systems 1606 Command Reference Manual page 887

Proto
comment
Fabric OS Command Reference
53-1001337-01
Laser_Flt The module is signaling a laser fault.
Port_Flt The port is marked faulty.
Diag_Flt The port failed diagnostics.
Lock_Ref The port is locking to the reference signal.
Testing The port is running diagnostics.
Offline A port connection is not established (for virtual ports only).
Online The port is up and running.
Protocol support by GbE port.
ISCSI The ports supports ISCSI.
FCIP The port supports FCIP.
FCoE The port supports Fibre Channel over Ethernet.
Optionally displays one of the following:
Copper or Optical
GbE port media configuration can be copper and optical (sfp). This parameter
is set by the portcfgGemediatype command.
Disabled The port is disabled.
Bypassed The port is bypassed (loop only).
Loopback The port is in loopback mode.
E_Port Fabric port; displays the world wide name (WWN) and name of the attached
switch. If the port is configured as an EX_Port, the WWN of the attached
switch is the same as the router.
F_Port Point-to-point port; displays the WWN of the attached N_Port. If that specific
F_Port receives 1 FDISK frame, switchShow displays the total number of NPIV
Public ports as 1, for example: F_Port 1 NPort + 1 NPIV devices.
G_Port Point-to-point port, but not yet E_Port or F_Port.
L_Port Loop port; displays the number of NL_Ports.
EX_Port Router port; displays the WWN of the attached edge switch.
VF_Port FCoE Virtual F_Port. For these ports, the number of NPIV or external device
logins is displayed ("n VN-Port(s)"), instead of the WWN of the internal port.
Mirror Port The port is a mirror port.
(Trunk master) The port is the master port in a group of trunking ports.
(Trunk port, master is port #x)
The port is configured as a trunking port; the master port is port #x.
(upstream) The E_Port is an upstream path toward the principal switch of the fabric.
(downstream) The E_Port is a downstream path away from the principal switch of the fabric.
Persistently Disabled
This port has been disabled with the portCfgPersistentDisable command.
2
switchShow
857