Brocade Communications Systems 1606 Command Reference Manual page 753

To display FICON EPCB for a GbE port 0 tunnel ID 1 with post display clearing of relevant statistics:
To display a list of discovered devices and selected path and status information on each. Get the
adrs from this display for the next command:
To display details on the FDCB specified in the adrs argument, which was derived from the previous
example:
To display the same information as the previous example but with post display clearing of relevant
statistics:
To display the inband management interfaces configured on the Brocade 7500:
Fabric OS Command Reference
53-1001337-01
VLAN Tagging Not Configured
TCP Byte Streaming on
Status : Active
Connected Count: 9
Uptime 23 hours, 19 minutes, 45 seconds
============================================
Streaming TCP vars:
============================================
head index
tail index
Current Count
Pending Frames High
Segment Count High
Data Mover Restarts
Data Mover Desc Full
Frame Too Large Count
Max Reference Count
Max Frame Size
Max Segments Pulled
Reached Max Pending Frames
FCIP Smoothed RTT
FCIP RTT Variance
FC control traffic TCP connection:
Local 192.168.32.1:4129, Remote 192.168.32.2:3225
Data transfer TCP connection:
Local 192.168.32.1:4130, Remote 192.168.32.2:3226
switch:admin> portshow ficon ge0 1 -epcb -clear
switch:admin> portshow ficon ge0 all -fdcb
switch:admin> portshow ficon ge0 all -fdcb 10008000
switch:admin> portshow ficon ge0 all -fdcb 10008000 -clear
switch:admin> portshow inbandmgmt ge1
Port: ge1
Inband Management: Enabled
CP Interface IP Address
----------------------------------------------
0 192.168.255.1
GE Interface IP Address
----------------------------------------------
0 192.168.255.2
= 24
= 24
= 0
= 16
= 3
= 0
= 0
= 0
= 15
= 2116
= 0
= 0
= 202 ms
= 1 ms
NetMask MTU
255.255.255.252 1500
NetMask MTU
255.255.255.252 1500
2
portShow
723