Brocade Communications Systems 1606 Command Reference Manual page 842

2
slotShow
Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS Commands" and Appendix A, "Command
Availability" for details.
Operands This command supports the following operands:
-p
-m
Examples To display a basic view of all slots and their status:
812
VACANT The slot is empty.
INSERTED, NOT POWERED ON
The blade is present in the slot but is turned off.
POWERING UP The blade is present and powering on.
LOADING The blade is present, powered on, and loading the initial configuration.
DIAG RUNNING POST1
The blade is present, powered on, and running the POST (power-on self-test).
DIAG RUNNING POST2
The blade is present, powered on, and running the pre-boot power on self
tests.
INITIALIZING The blade is present, powered on, and initializing hardware components.
ENABLED The blade is on and fully enabled.
ENABLED (SAS Virtualization Disabled)
The blade is on, but due to an incompatibility between the FOS image and the
SAS or Application image, the SAS Virtualization services are disabled. Only
applies to the FA4-18 blade.
DISABLED The blade is powered on but disabled.
FAULTY The blade is faulty because an error was detected.
UNKNOWN The blade is inserted but its state cannot be determined.
In addition to the basic slot status view, displays the following information
about power consumption:
•
Direct current (DC) power consumption for each Blade in Watts.
•
Total alternate current (AC) Power Consumption in Watts.
•
AC efficiency, as a percentage of total and BTU.
•
Power efficiency in Watts/port and Watts/Gb.
In addition to the basic slot status view, displays the Brocade model name for
each blade.
switch:user> slotshow
Slot Blade Type ID
-----------------------------------
1 SW BLADE 51
2 SW BLADE 51
3 SW BLADE 55
4 SW BLADE 51
5 CORE BLADE 52
Status
FAULTY
DISABLED
ENABLED
DIAG RUNNING POST2
ENABLED
Fabric OS Command Reference
53-1001337-01