Brocade Communications Systems 1606 Command Reference Manual page 193

--delete -tapepool
--modify -tapepool
--manual_rekey
--manual_rekey -all
Fabric OS Command Reference
53-1001337-01
-encrypt | -cleartext
Enables encryption or cleartext (no encryption). By default, cleartext is
enabled.
-key_lifespan time_in_days | none
Specifies the lifespan of the encryption key in days. The key expires after the
specified number of days. The default value is none, which means the key
does not expire until the value is set. This parameter cannot be modified for
tape pools once it is set.
Deletes the specified tape pool. This command is valid only on the group
leader. The following operand is required:
-label pool_label | -num pool_num
Specifies the tape pool by volume label or tape pool ID. Use --show
-tapepool for a listing of configured tape pools and their respective labels or
IDs.
Modifies the encryption policies of a specified tape pool. This command is
valid only on the group leader. The following operand is required:
-label pool_label | -num pool_num
Specifies the tape pool by volume label or tape pool ID. Use --show
-tapepool for a listing of configured tape pools and their respective labels or
IDs. To modify the label or pool number, you must delete and recreate the
tape pool.
You may optionally modify the following tape policy parameters. Refer to cryptocfg --create
-tapepool for descriptions of these parameters. Exercise caution when modifying tape pool
policy parameters while tape sessions are in progress. Refer to the Fabric OS Administrator's
Guide for more information.
[-encryption_format native | DF_compatible]
[-encrypt | -cleartext]
Performs a manual re-keying of a specified LUN associated with a specified
CTC. Manual re-keying is performed in both online and offline fashion
depending on whether or not the host is online or host I/O is present. If any
policy-based re-keying operation is currently in progress, this command
aborts with a warning message. This command is valid only on the group
leader.
The following operands are supported:
crypto_target_container_name
Specifies the name of the CTC to which this LUN belongs.
LUN_Num Specifies the number of the LUN to be re-keyed. Use --show -container for a
list of LUN numbers associated with the specified CTC.
initiator_PWWN Specifies the port WWN of the initiator for the specified LUN.
Performs a manual re-keying of all encrypted disk LUNs in the encryption
group. This operation may take an extended period of time.
2
cryptoCfg
163