Brocade Communications Systems 1606 Command Reference Manual page 720

2
portShow
The following general information is displayed when the command is issued for a non-GbE port
without additional arguments:
portName
portHealth
Authentication
portDisableReason
portCFlags
portFlags
portType
portState
Protocol
portPhys
portScn
690
Name assigned to the port by the portName command.
Current health of the port (requires a Fabric Watch license).
Authentication type and associated parameters (ifapplicable) used on the
port at port online.
None No authentication was performed.
FCAP FCAP authentication was performed.
DHCHAP DHCHAP authentication was performed. Also displays DH group and hash
type used for authentication.
Provides an explanation for the port's disabled status, if it has not been
disabled by portDisable or portCfgPersistentDisable.
Port control flags.
A bit map of port status flags, including information on the type of port,
whether it is fully online, and whether logins have been accepted.
The port's type and revision numbers.
The port's SNMP state:
Online Up and running.
Offline Not online, see portPhys for more detail.
Testing Running diagnostics.
Faulty Failed diagnostics.
Persistently Disabled
Persistently disabled.
Protocol used by the port: FC or FCoE.
The port's physical state:
No_Card No interface card present.
No_Module No module (GBIC or other) present.
No_Light Module is not receiving light.
Mod_Inv Incompatible vendor or module speed mismatch.
No_Sync Receiving light but out of sync.
In_Sync Receiving light and in sync.
Laser_Flt Module is signaling a laser fault.
Port_Flt Port marked faulty.
Diag_Flt Port failed diagnostics.
Lock_Ref Locking to the reference signal.
The port's last State Change Notification.
Fabric OS Command Reference
53-1001337-01