Brocade Communications Systems 1606 Command Reference Manual page 615

fcipcircuit
Fabric OS Command Reference
53-1001337-01
Creates an FCIP circuit on an existing tunnel. Use this command to configure
additional circuits. The circuit-specific parameters are optional. The syntax for
portcfg fcipcircuit is as follows:
portcfg fcipcircuit [slot/]ve_port option circuit_ID options [arguments]
[optional_arguments]
The following options and arguments are supported with fcipcircuit:
create circuit_ID remote_ip_addr local_ip_addr comm_rate
Creates an FCIP circuit. Specify the following:
circuit_ID Specifies a numeric identifier for the circuit. The circuit ID is an integer
value between 0-9 both on the Brocade FX8-24 and on the Brocade
7800.
remote_ip_addr
Specifies the IP address for the remote end of the FCIP circuit. IPv6
addresses are currently not supported.
local_ip_addr Specifies the IP address for the local end of the FCIP circuit. IPv6
addresses are currently not supported.
The following operands are exclusive:
comm_rate
Specifies the committed traffic rate on the FCIP tunnel in Kbps. The valid
range is 1544 Kbps - 1000000 Kbps. There is no default. Both sides of
the tunnel must have matching configurations.
--min-comm-rate value, --max-comm-rate value
Alternately you may set a minimum and a maximum for the committed
rate to configure the tunnel for Adaptive Rate Limiting (ARL), which allows
for a more effective sharing of bandwidth between applications. The valid
range is 1544 Kbps - 1000000 Kbps. Both sides of the tunnel must have
matching configurations.
modify [circuit_ID] [circuit_arguments]
Modifies the properties of an existing FCIP circuit. To modify a circuit, you
must specify at least one of the circuit parameters for the command to be
effective. Any circuit attribute you change with the fcipcircuit modify
command affects only the specified FCIP circuit. All other circuits remain
unchanged.
Optional arguments for fcipcircuit create and modify include:
-a |--admin-status 0|1
Enables (1) or disables (0) the circuit.
-s |--sack 0|1
Disables or enables selective acknowledgement code (SACK) on the FCIP
circuit. SACK is by default enabled.
-k |--keepalive-timeout timeout
Specifies the keep alive timeout in milliseconds. The valid range is
500ms – 7200000ms. The default value is 5000ms.
2
portCfg
585