Interfaceshow - Brocade Communications Systems 1606 Command Reference Manual

2

interfaceShow

interfaceShow
Displays FSPF interface information.
Synopsis interfaceshow [slotnumber/][portnumber]
Description Use this command to display the two data structures associated with FSPF interfaces (E_Ports) on
the switch:
•
•
This command displays the content of both data structures, if they have been allocated.
The following fields are displayed:
378
The permanently allocated interface descriptor block (IDB).
The neighbor data structure. This data structure is allocated when a switch port becomes an
E_Port. The neighbor data structure contains all the information relating to the switch that is
connected to an adjacent switch.
idbP Pointer to IDB.
nghbP Pointer to neighbor data structure.
ifNo Interface number.
masterPort Port number of the trunk master port, if present, of the trunk group of which
this port is a part.
defaultCost Default cost of sending a frame over the interswitch link (ISL) connection to
this interface.
cost Cost of sending a frame over the ISL connected to this interface. A value of
1000 indicates a 1-Gbps link. A value of 500 indicates a 2-Gbps link. For links
with a bandwidth greater than 2 Gbps, the cost is 500. For links with less
than 1 Gbps, the cost is 2000. Refer to linkCost for more information.
delay Conventional delay incurred by a frame transmitted on this ISL. A fixed value
required by the FSPF protocol.
lastScn Type of the last State Change Notification received on this interface.
lastScnTime Time the last State Change Notification was received on this interface.
upCount Number of times this interface came up, with respect to FSPF.
lastUpTime Last time this interface came up.
downCount Number of times this interface went down.
lastDownTime Last time this interface went down.
downReason Type of last State Change Notification that caused this interface to go down.
iState Current state of this interface. The state can be UP or DOWN. An interface in
DOWN state does not have an allocated neighbor data structure and cannot
be used to route traffic to other switches.
state Current state of this interface. This E_Port is used to route traffic to other
switches only if the state is NB_ST_FULL.
lastTransition Time the last state changed on this interface.
nghbCap Neighbor capabilities. Should be 0.
Fabric OS Command Reference
53-1001337-01