Brocade Communications Systems 1606 Command Reference Manual page 617

Brocade fabric os command reference v6.3.0 (53-1001337-01, july 2009)

Hide thumbs Also See for 1606:

Table of Contents

To set the compression rate to 'moderate' on the tunnel:

To enable and configure FICON emulation on the tunnel:

To configure FastWrite and Tape Pipelining on the tunnel:

To delete circuit 1:

Commands supported only on the Brocade 7500/7500E and the Brocade FR4-18i platforms

portcfg action [slot/] ge_port arguments

Use this command to manage configuration parameters for ports and Gigabit Ethernet (GbE) ports

on the Brocade 7500 and 7500E FC Router switches and on the FR4-18i FC Router blade. The

following commands are exclusive to these platforms.

This command supports the following operands:

Fabric OS Command Reference

53-1001337-01

Path MTU Disc: 0

Flags: 0x00000000

switch:admin> portcfg fciptunnel 1/12 modify -c 2

Operation succeeded

switch:admin>portcfg fciptunnel 1/12 modify -F 1 --ficon xrc 1

Operation succeeded

switch:admin>portcfg fciptunnel 1/12 modify -f 1 -t 1

Operation succeeded

switch:admin>portcfg fcipcircuit 1/12 delete 1

Operation succeeded

portcfg arp - Add and delete address resolution protocol (ARP) entries. Flush ARP table.

portcfg fciptunnel - Create, modify, and delete Fibre Channel over IP (FCIP) tunnels.

Delete, reset, and modify QoS mappings on an existing tunnel.

Create or modify a tunnel with VLAN tagging and Class of Service (CoS).

Create or modify a tunnel with Tape read/write Pipelining enabled or disabled.

Create or modify a tunnel with Byte Streaming enabled or disabled.

portcfg mirrorport - Configure a mirror port on the local port.

portcfg rscnsuppr - Manage registered state change notification (RSCN) suppression on the

portcfg faswrite - Configure the FC port for FC Fastwrite.

portcfg ficon - Manage FICON emulation in an FCIP tunnel.

portcfg vlantag - Manage VLAN Tagging configuration for FCIP.

For bladed systems only, specifies the slot number of the port to be

configured, followed by a slash (/).