Snmpv3 Configuration - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Cli Reference Manual

Table 81 System SNMP Configuration commands
Command
snmp-server write-
community <1-32
characters>
snmp-server timeout <1-
30>
[no] snmp-server
authentication-trap
enable
[no] snmp-server link-
trap
[no] snmp-server ufd-
trap
show snmp-server

SNMPv3 configuration

SNMP version 3 (SNMPv3) is an extensible SNMP Framework that supplements the SNMPv2 Framework by
supporting the following:
a new SNMP message format
security for messages
access control
remote configuration of SNMP parameters
For more details on the SNMPv3 architecture please see RFC2271 to RFC2275.
The following table describes the SNMPv3 Configuration commands.
Table 82 SNMPv3 Configuration commands
Command
snmp-server user <1-16>
snmp-server view <1-128>
snmp-server access <1-32>
snmp-server group <1-16>
snmp-server community <1-
16>
Description
Configures the SNMP write community string. The write community string controls SNMP
"set" and "get" access to the switch. It can have a maximum of 32 characters. The
default write community string is private.
Command mode: Global configuration
Sets the timeout value for the SNMP state machine. The range is 1-30 minutes. The
default value is 5 minutes.
Command mode: Global configuration
Enables or disables the use of the system authentication trap facility. The default setting
is disabled.
Command mode: Global configuration
Enables or disables the sending of SNMP link up and link down traps. The default
setting is enabled.
Command mode: Global configuration
Enables or disables the sending of Uplink Failure Detection traps. The default setting is
disabled.
Command mode: Global configuration
Displays the current SNMP configuration.
Command mode: All
Description
Configures a user security model (USM) entry for an authorized user. You can also
configure this entry through SNMP. The range is 1-16.
Command mode: Global configuration
Configures different MIB views. The range is 1-128.
Command mode: Global configuration
Configures access rights. The View-based Access Control Model defines a set of
services that an application can use for checking access rights of the user. You need
access control when you have to process retrieval or modification request from an
SNMP entity. The range is 1-32.
Command mode: Global configuration
Configures an SNMP group. A group maps the user name to the access group
names and their access rights needed to access SNMP management objects. A
group defines the access rights assigned to all names that belong to a particular
group. The range is 1-16.
Command mode: Global configuration
Configures a community table entry. The community table contains objects for
mapping community strings and version-independent SNMP message parameters.
The range is 1-16.
Command mode: Global configuration
Configuration Commands 88