Idle Timeout; Typographical Conventions - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Cli Reference Manual

Table 2 User access levels
User account
User
Oper
Admin
NOTE: With the exception of the admin user, access to each user level can be disabled by setting the
password to an empty value.
Once you enter the administrator password and it is verified, you are given complete access to the GbE2c.

Idle timeout

By default, the GbE2c disconnects the console, Telnet, or SSH session after five minutes of inactivity. This function is
controlled by the idle timeout parameter, which can be set from 1 to 60 minutes. To change this parameter, see the
"System configuration" section in the "Configuration Commands" chapter.

Typographical conventions

The following table describes the typographic styles used in this guide:
Typeface or symbol
angle brackets < >
bold body text
bold Courier text
plain Courier text
braces { }
Description and tasks performed
The User has no direct responsibility for switch management. He or she can view all switch status
information and statistics, but cannot make any configuration changes to the switch.
The user account is enabled by default, and the default password is user.
The Operator has no direct responsibility for switch management. He or she can view all switch
status information and statistics, but cannot make any configuration changes to the switch.
By default, the operator account is disabled and has no password.
The super user administrator has complete access to all command modes on the switch, including
the ability to change both the user and administrator passwords.
The admin account is enabled by default, and the default password is admin.
Meaning
Indicate a variable to enter based on the description inside the brackets. Do not type
the brackets as you enter the command.
Example: If the command syntax is
IP address
ping <
Enter:
ping 192.32.10.12
Indicates objects, such as window names, icons, and user-interface objects, such as
buttons and tabs.
Indicates command names, options, and text that you must enter.
Example:
Use the
show ip arp
Indicates command syntax and system output (for example: prompts and system
messages). Example:
configure terminal
Indicate required elements in syntax descriptions where there is more than one
option. You must choose only one of the options. Do not type the braces when
entering the command.
Example: If the command syntax is
show portchannel {<1-12>|hash|information}
Enter:
show portchannel <1-12>
or
show portchannel hash
or
show portchannel information
>
command.
ISCLI Reference 11