Ip Static Route Configuration; Address Resolution Protocol Configuration; Ip Forwarding Configuration - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Cli Reference Manual

IP Static Route configuration

NOTE: These commands are available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
The following table describes the Static Route Configuration commands.
Table 120 Static Route Configuration commands
Command
ip route <IP subnet> <IP
netmask> <IP nexthop> [<IP
interface (1-256)>]
no ip route {<IP subnet>}{<IP
netmask>}
show ip route static

Address Resolution Protocol configuration

Address Resolution Protocol (ARP) is the TCP/IP protocol that resides within the Internet layer. ARP resolves a physical
address from an IP address. ARP queries machines on the local network for their physical addresses. ARP also
maintains IP to physical address pairs in its cache memory. In any IP communication, the ARP cache is consulted to
see if the IP address of the computer or the router is present in the ARP cache. Then the corresponding physical
address is used to send a packet.
The following table describes the ARP Configuration commands.
Table 121 ARP Configuration commands
Command
ip arp rearp <2-120>
show ip arp

IP Forwarding configuration

NOTE: IP Forwarding commands are available only on the GbE2c Layer 2/3 Ethernet Blade Switch.
The following table describes the IP Forwarding Configuration commands.
Table 122 IP Forwarding Configuration commands
Command
[no] ip routing direct-
broadcasts
ip routing
no ip routing
show ip routing
Description
Adds a static route. You will be prompted to enter a destination IP
address, destination subnet mask, and gateway address. Enter all
addresses using dotted decimal notation.
Command mode: Global configuration
Removes a static route. The destination address of the route to remove
must be specified using dotted decimal notation.
Command mode: Global configuration
Displays the current IPstatic route configuration.
Command mode: All except User Exec
Description
Defines re-ARP period in minutes. You can set this duration between 2 and 120
minutes.
Displays the current ARP configurations.
Command mode: All except User EXEC
Description
Enables or disables forwarding directed broadcasts. This command is disabled
by default.
Command mode: Global configuration
Enables IP forwarding (routing) on the GbE2c.
Command mode: Global configuration
Disables IP forwarding (routing) on the GbE2c. Forwarding is turned off by
default.
Command mode: Global configuration
Displays the current IP forwarding settings.
Command mode: All except User EXEC
Configuration Commands 112