Acl Port Configuration; Layer 2 Configuration; 802.1X Configuration - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Cli Reference Manual

ACL Port configuration

The following table describes the basic Access Control List Configuration commands for the port.
Table 98 ACL Port Configuration commands
Command
[no] access-control list <1-762>
[no] access-control group <1-762>
show interface port [<port number>]
access-control

Layer 2 configuration

The following table describes the Layer 2 Configuration commands. The following sections provide more detailed
information and commands.
Table 99 Layer 2 Configuration commands
Command
vlan {<1-4095>}
[no] spanning-tree
uplinkfast
spanning-tree uplinkfast
max-update-rate <10-200>
show layer2

802.1x configuration

This feature allows you to configure the GbE2c as an IEEE 802.1x Authenticator, to provide port-based network
access control. The following table describes the 802.1x Configuration commands.
Table 100 802.1x Configuration commands
Command
dot1x enable
no dot1x enable
show dot1x
Description
Adds or removes the specified ACL.
Command mode: Interface port
Adds or removes the specified ACL Group.
Command mode: Interface port
Displays current ACL QoS parameters.
Command mode: All
Description
Enter VLAN configuration mode.
Command mode: Global configuration
Enables or disables Fast Uplink Convergence, which provides rapid Spanning
Tree convergence to an upstream switch during failover.
Note: When enabled, this feature increases bridge priorities to 65500 for all
STGs and path cost by 3000 for all external STP ports.
Command mode: Global configuration
Configures the station update rate, in packets per second.
The range is 10-200. The default value is 40.
Command mode: Global configuration
Displays current Layer 2 parameters.
Command mode: All
Description
Globally enables 802.1x.
Command mode: Global configuration
Globally disables 802.1x.
Command mode: Global configuration
Displays current 802.1x parameters.
Command mode: All
Configuration Commands 98