Setting An Ip Address; Establishing A Telnet Connection; Establishing An Ssh Connection - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Cli Reference Manual

To establish a console connection with the switch:
1. Connect the terminal to the console port using the null modem cable.
2. Power on the terminal.
3. Press the Enter key a few times on the terminal to establish the connection.
4. You will be required to enter a password for access to the switch.

Setting an IP address

To access the switch via a Telnet or an SSH connection, you need to have an Internet Protocol (IP) address set for the
switch. The switch can get its IP address in one of the following ways:
Management port access:
Using a Dynamic Host Control Protocol (DHCP) server—When the /cfg/sys/dhcp command is
enabled, the management interface (interface 256) requests its IP address from a DHCP server. The default
value for the /cfg/sys/dhcp command is enabled.
Configuring manually—If the network does not support DHCP, you must configure the management
interface (interface 256) with an IP address. If you want to access the switch from a remote network, you
also must configure the management gateway (gateway 4).
Uplink port access:
Using a Bootstrap Protocol (BOOTP) server—By default, the management interface is set up to request its IP
address from a BOOTP server. If you have a BOOTP server on the network, add the Media Access Control
(MAC) address of the switch to the BOOTP configuration file located on the BOOTP server. The MAC
address can be found in the System Information (See the "System information" section in the "Information
Commands" chapter.) If you are using a DHCP server that also does BOOTP, you do not have to configure
the MAC address.
Configuring manually—If the network does not support BOOTP, you must configure the management port
with an IP address.

Establishing a Telnet connection

A Telnet connection offers the convenience of accessing the GbE2c from any workstation connected to the network.
Telnet provides the same options for user, operator, and administrator access as those available through the console
port. By default, Telnet is enabled on the switch. The switch supports four concurrent Telnet connections.
Once the IP parameters are configured, you can access the ISCLI using a Telnet connection. To establish a Telnet
connection with the switch, run the Telnet program on the workstation and enter the telnet command, followed by the
switch IP address:
telnet <GbE2c Ethernet Blade Switch IP address>
You will then be prompted to enter a password. The password determines the access level: administrator, operator,
or user. See the "Accessing the switch" section later in this chapter for description of default passwords.

Establishing an SSH connection

Although a remote network administrator can manage the configuration of a switch via Telnet, this method does not
provide a secure connection. The Secure Shell (SSH) protocol enables you to securely log into the GbE2c over the
network.
As a secure alternative to using Telnet to manage switch configuration, SSH ensures that all data sent over the
network is encrypted and secure. In order to use SSH, you must first configure it on the switch. See the "Secure Shell
Server configuration" section in the "Configuration Commands" chapter for information on how to configure SSH.
The switch can perform only one session of key/cipher generation at a time. Therefore, an SSH/Secure Copy (SCP)
client will not be able to log in if the switch is performing key generation at that time or if another client has just
logged in before this client. Similarly, the system will fail to perform the key generation if an SSH/SCP client is
logging in at that time.
ISCLI Reference 9