802.1X Port Configuration - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Cli Reference Manual

802.1x Port configuration

The 802.1x port commands allow you to configure parameters that affect the selected port in the switch. These
settings override the global 802.1x parameters.
The following table describes the 802.1x Port Configuration commands.
Table 102 802.1x Global Configuration commands
Command
dot1x mode {[force-unauthorized|
auto|force-authorized]}
dot1x quiet-time {<0-65535>}
dot1x transmit-interval
{<1-65535>}
dot1x supplicant-timeout
{<1-65535>}
dot1x server-timeout {<1-65535>}
dot1x max-request {<1-10>}
dot1x re-authentication-interval
{<1-604800>}
[no] dot1x re-authenticate
default dot1x
show dot1x
Description
Sets the type of access control for the port:
- the port is unauthorized unconditionally.
force-unauth
- the port is unauthorized until it is successfully authorized by
auto
the RADIUS server.
- the port is authorized unconditionally, allowing all
force-auth
traffic.
The default value is
force-auth
Command mode: Interface port
Sets the time, in seconds, the authenticator waits before transmitting an
EAP-Request/ Identity frame to the supplicant (client) after an
authentication failure in the previous round of authentication. The default
value is 60 seconds.
Command mode: Interface port
Sets the time, in seconds, the authenticator waits for an EAP-
Response/Identity frame from the supplicant (client) before retransmitting
an EAP-Request/Identity frame. The default value is 30 seconds.
Command mode: Interface port
Sets the time, in seconds, the authenticator waits for an EAP-Response
packet from the supplicant (client) before retransmitting the EAP-Request
packet to the authentication server. The default value is 30 seconds.
Command mode: Interface port
Sets the time, in seconds, the authenticator waits for a response from the
RADIUS server before declaring an authentication timeout. The default
value is 30 seconds.
Command mode: Interface port
Sets the maximum number of times the authenticator retransmits an EAP-
Request packet to the supplicant (client). The default value is 2.
Command mode: Interface port
Sets the time, in seconds, the authenticator waits before re-
authenticating a supplicant (client) when periodic re-authentication is
enabled. The default value is 3600 seconds.
Command mode: Interface port
Sets the re-authentication status to
Command mode: Interface port
Resets the global 802.1x parameters to their default values.
Command mode: Interface port
Displays current global 802.1x parameters.
Command mode: All
.
or . The default value is
on off
Configuration Commands 100
.
off