Show All Fdb Information; Link Aggregation Control Protocol Information - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Cli Reference Manual

Show all FDB information

The following command displays Forwarding Database information:
show mac-address-table
Command mode: All
MAC address
-----------------
00:02:01:00:00:00
00:02:01:00:00:01
00:02:01:00:00:02
00:02:01:00:00:03
00:02:01:00:00:04
00:02:01:00:00:05
00:02:01:00:00:06
00:02:01:00:00:07
00:02:01:00:00:08
00:02:01:00:00:09
00:02:01:00:00:0a
00:02:01:00:00:0b
00:02:01:00:00:0c
An address that is in the forwarding (FWD) state indicates that the switch has learned it. When in the trunking (TRK)
state, the Trnk field displays the trunk group number. If the state for the port is listed as unknown (UNK), the MAC
address has not yet been learned by the switch, but has only been seen as a destination address. When an address
is in the unknown state, no outbound port is indicated.
Clearing entries from the forwarding database
To delete a static MAC address from the forwarding database (FDB), see the "Static FDB configuration" section in the
"Configuration Commands" chapter.

Link Aggregation Control Protocol information

The following table describes the Link Aggregation Control Protocol information commands.
Table 19 LACP information commands
Command
show interface port <port number> lacp
aggregator
show lacp
show lacp information
VLAN Port Trnk State
---- ---- ---- -----
300 1 TRK
300 23 FWD
300 23 FWD
300 23 FWD
300 23 FWD
300 23 FWD
300 23 FWD
300 23 FWD
300 23 FWD
300 23 FWD
300 23 FWD
300 23 FWD
300 23 FWD
Usage
Displays LACP aggregator information for the port.
Command mode: All
Displays LACP information for the port.
Command mode: All
Displays all LACP information parameters.
Command mode: All
Information Commands 28