Radius Server Configuration - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Cli Reference Manual

Table 77 SSHD Configuration commands
Command
ssh generate-server-key
ssh port <TCP port number>
ssh scp-enable
no ssh scp-enable
ssh enable
no ssh enable
show ssh

RADIUS server configuration

NOTE: See the HP GbE2c Ethernet Blade Switch for c-Class BladeSystem Application Guide for information on
RADIUS.
The following table describes the RADIUS Server Configuration commands.
Table 78 RADIUS Server Configuration commands
Command
[no] radius-server primary-host
<IP address> key <1-32
characters>
[no] radius-server secondary-
host <IP address> key <1-32
characters>
radius-server port <UDP port
number>
radius-server retransmit <1-3>
radius-server timeout <1-10>
[no] radius-server telnet-
backdoor
[no] radius-server secure-
backdoor
Description
Generates the RSA server key. The switch creates this key automatically while
configuring the switch with Secure Shell (SSH). You can generate the key manually
by using this command if you need to overwrite the key for security reasons. The
command will take effect immediately.
Command mode: Global configuration
Sets the SSH server port number.
Command mode: Global configuration
Enables the SCP apply and save.
Command mode: Global configuration
Disables the SCP apply and save. This is the default for SCP.
Command mode: Global configuration
Enables the SSH server.
Command mode: Global configuration
Disables the SSH server. This is the default for the SSH server.
Command mode: Global configuration
Displays the current SSH server configuration.
Command mode: All
Description
Sets the primary RADIUS server address and shared secret between the
switch and the RADIUS server(s).
Command mode: Global configuration
Sets the secondary RADIUS server address and shared secret between the
switch and the RADIUS server(s).
Command mode: Global configuration
Enter the number of the User Datagram Protocol (UDP) port to be
configured, between 1500-3000. The default is 1645.
Command mode: Global configuration
Sets the number of failed authentication requests before switching to a
different RADIUS server. The range is 1-3 requests. The default is 3
requests.
Command mode: Global configuration
Sets the amount of time, in seconds, before a RADIUS server
authentication attempt is considered to have failed. The range is 1-10
seconds. The default is 3 seconds.
Command mode: Global configuration
Enables or disables the RADIUS back door for telnet/SSH/ HTTP/HTTPS.
This command does not apply when secure backdoor is enabled.
Command mode: Global configuration
Enables or disables the RADIUS back door using secure password for
telnet/SSH/ HTTP/HTTPS. This command does not apply when backdoor
(telnet) is enabled.
Command mode: Global configuration
Configuration Commands 84