Information Commands Introduction - HP GbE2c - Blc Layer 2/3 Fiber SFP Option Cli Reference Manual

Information Commands
Introduction
You can view configuration information for the switch in the ISCLI. This chapter discusses how to use the ISCLI to
display switch information.
The following table describes general information commands.
Table 5 Information commands
Command
show sys-info
show layer2 information
show layer3 information
show rmon
show interface link
show interface information
show geaport
show ufd
show information-dump
Usage
Displays system information.
Command mode: All
Displays Layer 2 information.
Command mode: All
Displays Layer 3 information.
Command mode: All
Displays Remote Monitoring Information.
Command mode: All
Displays configuration information about each port, including:
Port number
Port speed (10 Mb/s, 100 Mb/s, 1000 Mb/s, or any)
Duplex mode (half, full, or any)
Flow control for transmit and receive (no, yes, or any)
Link status (up or down)
Command mode: All except User EXEC
Displays port status information, including:
Port number
Whether the port uses VLAN tagging or not
Port VLAN ID (PVID)
Port name
VLAN membership
Command mode: All except User EXEC
Displays GEA port mapping information, used by service personnel.
Command mode: All
Displays Uplink Failure Detection information.
Command mode: All
Dumps all switch information available (10K or more, depending on your
configuration).
If you want to capture dump data to a file, set your communication software
on your workstation to capture session data prior to issuing the dump
commands.
Command mode: All
Information Commands 16