Turning On The Power; Starting Auto Setup - Denon AVR-4806CI Operating Instructions Manual

Turning on the power

1
Turn on your subwoofer.
Set the volume to halfway and set the crossover
frequency to the maximum or Low pass filter off if your
subwoofer can adjust the output volume and the
crossover frequency.
Some subwoofers have a standby mode. Be sure to
turn this function off before performing the Auto Setup
procedure.
2
Turn on your TV (monitor).
3
POWER
Press the
ON:
¢
The power turns on and the power indicator lights.
Set the POWER switch to this position to turn the
power on and off from the included remote control
unit.
OFF:
£
The power turns off and indicator is off.
In this position, the power cannot be turned on and
off from the remote control unit.
4
ON/STANDBY
Press the
ON
unit or button on the remote control unit.
• When pressed, the power turns on and the display
lights.
• When pressed again, the power turns off, the
standby mode is set and the display turns off.
The sound is muted for several seconds, after which
the unit operates normally.
Whenever the ON/STANDBY button is in the standby
state, the apparatus is still connected to the AC line
voltage. Please be sure to turn off the POWER switch or
unplug the cord when you leave home for, say, a
vacation.
5
AMP
Press the button to select "AMP" (only
when operating with the remote control unit).
switch.
switch on the main

Starting Auto Setup

1
SYSTEM SETUP
Press the
• Display the "System Setup Menu".
2
CURSOR
Press the
"Auto Setup / Room EQ", then press the
ENTER
button.
• Display the "Auto Setup / Room EQ" menu screen.
3
CURSOR
Press the
"Auto Setup", then press the
• Display the "Auto Setup" screen.
The message "Connect Microphone" is displayed if no
microphone is connected. If so, connect the auto setup
microphone.
21
Easy Setup and Operation
button.
D D or H H button to select
D D or H H button to select
ENTER
button.