Playback Using The External Input (Ext. In) Terminals; Turning The Sound Off Temporarily (Muting); Listening Over Headphone - Denon AVR-4806CI Operating Instructions Manual

Playback using the external input (EXT. IN)
terminals
EXT. IN
Press the button on the main unit or INPUT
MODE button on the remote control unit to switch
the external input.
When operating the remote control unit:
(Remote control unit)
The mode switches as shown below each time the
INPUT MODE button is pressed:
AUTO PCM
EXT.IN
• Cancelling the external input mode:
Press the INPUT MODE or ANALOG button to switch to the
desired input mode (
• The external input mode can be set for any input source. To
watch video while listening to sound, select the input source
to which the video signal is connected, then set this mode.
• If the subwoofer output level seems too high, set the "SW
ATT" surround parameter to "ON".
NOTE:
• When the input mode is set to the external input (EXT. IN),
the surround mode (DIRECT, STEREO, HOME THX
CINEMA, STANDARD, 7CH STEREO, WIDE SCREEN or
DSP SIMULATION) cannot be set.
• In play modes other than the external input mode, the
signals connected to these terminals cannot be played. In
addition, signals cannot be output from channels not
connected to the input terminals.
DTS
ANALOG
page 47).
Turning the sound off temporarily
(MUTING)
• Use this to mute the audio output temporarily.
MUTE
Press the button.
You can adjust the muting level (
• Cancelling MUTING mode:
Press the MUTE button again, or press the VOLUME button on
the remote control, or adjust the volume up or down via the
front panel VOLUME knob.

Listening over headphone

Connect the headphone to the
• The pre-out output (including the speaker output) is
automatically turned
connected.
NOTE:
• To prevent hearing loss, be careful not to raise the volume
level excessively when using headphones.
45
Basic Operation
page 118).
PHONES
jack.
off when headphones are