Outputting A Program Source To An Amplifier, Etc., In A Zone2 Room (Zone2 Select Mode); Outputting A Program Source To An Amplifier, Etc., In A Zone3 Room (Zone3 Select Mode) - Denon AVR-4806CI Operating Instructions Manual

Advanced Operation
FUNCTION ZONE3/REC SELECT
ZONE2 SELECT
Outputting a program source to an
amplifier, etc., in a ZONE2 room
(ZONE2 SELECT mode)
1
ZONE2 SELECT
Press the
"ZONE2 SOURCE" on the display.
2
FUNCTION
Turn the
you want to output appears on the display.
3
Start playing the source to be output.
For operating instructions, refer to the manuals of the
respective components.
button to display the
knob to select the source
AMP
ZONE2 ON/OFF
MUTE
Outputting a program source to an
amplifier, etc., in a ZONE3 room
(ZONE3 SELECT mode)
1
ZONE3/REC SELECT
Press the
display the "ZONE3 SOURCE" on the display.
• The MULTI indicator light.
The display switches as follows each time the button
is pressed.
ZONE3
2
FUNCTION
Turn the
you want to output appears on the display.
3
Start playing the source to be output.
For operating instructions, refer to the manuals of the
respective components.
• The signals of the source selected in the ZONE3 mode are
also output from the VCR-1, VCR-2, VCR-3 and CDR/TAPE
recording output terminals.
• Digital signals are not output from the ZONE2 and ZONE3
audio output terminals.
• About the MULTI ZONE connections (
• Digital outputs of the OPTICAL2, 3 and 4 OUT normally
switch in association with the ZONE3/REC SELECT mode,
but if "ZONE2 SELECT" is selected at "Digital Out Assign",
the source switches in association with the "ZONE2
SELECT" mode for the OPTICAL2 OUT digital output
terminal ( page 121).
92
ZONE3 ON/OFF
VOLUME
button to
RECOUT
knob to select the source
page 90, 91).