Extra Setup; Preliminary Measurements - Denon AVR-4806CI Operating Instructions Manual

Easy Setup and Operation

Extra Setup

• The AVR-4806CI has seven available amplifier channels,
some of which can be assigned for powering speakers in
ZONE2 and ZONE3, depending on the speaker system
complement in the main room. If this functionality is not
needed, skip this "Extra Setup" procedure and proceed to

"Preliminary Measurements".

1
CURSOR
Press the
"Extra Setup", then press the
button.
• Switch to the "Extra Setup" screen.
2
CURSOR
Press the
setting you want to change, then press the
ENTER
button.
• Switch to the setting screen.
For instructions on making the "Channel Setup"
settings ( page 115).
For instructions on making the "Power Amp Assign"
settings ( page 116, 117).
The speakers measured with this Auto Setup
procedure are based on the setting of these "Channel
Setup" and "Power Amp Assign" functions.
3
Once the settings are completed, press the
ENTER
button at the each setting screen.
• The "Extra Setup" menu reappears.
4
CURSOR
Press the
"Exit", then press the
• Return to the "Auto Setup" screen.
D D or H H button to select
CURSOR
D D or H H button to choose the
D D or H H button to select
ENTER
button.
Preliminary measurements
• This procedure is used to automatically determine the
background noise, whether or not speakers are connected,
and the polarities of the connected speakers.
• To avoid affecting the measurements, turn off the air-
conditioner or any other device that makes noise and take
the measurements with the room as quiet as possible.
1
CURSOR
Press the
F F "Start", then press the
• Start the preliminary measurements.
The screen shown at the below appears once the
preliminary measurements are completed.
2
ENTER
Press the
• Switch to the "Speaker Detect Check" screen.
3
Check the results of the speaker detection,
then press the
• Switch to the second screen.
4
If the check ends, press the
again.
22
D D or H H button to select
CURSOR F F button.
button.
[ First screen ]
ENTER
button.
[ Second screen ]
ENTER
button