Check Of The Measurement Result - Denon AVR-4806CI Operating Instructions Manual

Easy Setup and Operation

Check of the measurement result

• The results of the measured items can be checked.
1
CURSOR
Press the
items, then press the
• Switch to the verification screen.
Example: Speaker Config. Check
2
ENTER
Press the button.
• Switch to the second screen.
Example: Speaker Config. Check
[ Second screen ]
3
If the check ends, press the
again.
4
CURSOR
Press the
whether or not to save the data you have
checked.
Store:
Set with the checked measurement value.
All parameters are stored up.
Cancel:
Cancel the auto setup settings.
D D or H H button to select
ENTER
button.
[ First screen ]
ENTER
button
D D or H H button to select
5 CURSOR
Press the
• After the data is stored, the "Auto Setup / Room
EQ" menu screen appears automatically.
• Sometimes due to the electrical complexities of subwoofers and the
interaction with the room, THX recommends setting the level and
the distance of the subwoofer manually.
• Sometimes due to interaction with the room, you may notice
irregular results when setting the level and/or distance of the main
speakers. If this happens, THX recommends setting them manually.
• Please note that any THX main speakers should be set to Small (80
Hz). If you set up your speakers using Auto Setup, please make sure
manually that any THX speakers are set to Small with 80 Hz crossover.
• When measurements have been made using the
measurement microphone, speakers with a built-in filter
such as subwoofers might be set with a value that differs
from the physical distance because of the internal electrical
delay.
NOTE:
• Do not turn off the power while the data is being stored.
If the power is turned off while the data is being stored,
the Room EQ parameters stored in the memory will be
cleared, and it will not be possible to select "Audyssey",
"Front" or "Flat" equalizer settings.
24
F F button.