Configuring A Spa400 For Voice Mail Service; Voice Mail Capacity - Cisco SPA-841 - Sipura VoIP Phone Administration Manual

Administering the SPA400 and Voice Mail Service

Configuring a SPA400 for Voice Mail Service

Configuring a SPA400 for Voice Mail Service
NOTE
NOTE
SPA9000 Voice System Administration Guide
The SPA400 includes a USB adapter with an integrated voice mail application for
the users and extensions that are configured on the SPA9000. The integrated
voice mail application server supports 32 configurable voice mail accounts.
Although a SPA9000 can be configured with up to four SPA400 devices, only one
SPA400 can be configured with the voice mail server.
Important: For optimum voice mail performance, a SPA400 should be dedicated to
the voice mail application when either of the following conditions is met:
1) More than 2 FXO connections are required
—OR—
2) More than 2 users commonly access voice mail at the same time.
This section includes the following topics:
•
"Voice Mail Capacity," on page112
•
"Configuring Local Voice Mail Service on a SPA400," on page113
•
"Setting Up Voice Mail on Each Station," on page116
•
"Enabling Remote Voice Mail Access (Optional)," on page119
Before you begin any of the procedures in this section, configure a SPA9000 line
interface for this device. See
Voice Mail)," on page

Voice Mail Capacity

The provided 128-Mb USB drive can store more than 3.8 hours of messages
(approximately 230 60-second messages). For example, with 10 voice mail users,
each user can store up to 23 60-second messages. When disk capacity is
reached, inbound voice mail deposit attempts are disconnected. If additional voice
mail storage is required, please contact Linksys for recommended high-capacity
USB drives.
"Configuring a Line Interface for a SPA400 (PSTN or
60.
5
112