Configuring Spa9000 Fxs Ports - Cisco SPA-841 - Sipura VoIP Phone Administration Manual

Configuring Phone Lines and Calling Routing Behavior

Configuring SPA9000 FXS Ports

Configuring SPA9000 FXS Ports
NOTE
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
SPA9000 Voice System Administration Guide
The SPA9000 FXS ports can be used to connect analog phones and fax machines
to the SPA9000 Voice System. A port also can be configured for a Streaming
Audio Server for Music On Hold. See
A fax machine can be connected to the Phone port of the SPA9000. Fax support
through an ITSP line requires a T.38 fax machine on both ends and the availability
of T.38 FAX relay through the ITSP. T.38 support is dependent on fax machine and
network / transport resilience. Linksys makes no guarantee with the use of this
product regarding fax transmission services
Start Internet Explorer, and then enter the IP address of the SPA9000. Click Admin
Login and then click Advanced.
Click Voice tab > FXS
Scroll down to the Subscriber Information section, and then enter the following
settings:
•
Display Name: Enter an extension number of name for the FXS 1 port, such as
Receptionist Area Fax Machine. You can use this extension number to add the
analog phone to the contact list, hunt groups, and shared line appearances.
•
User ID: Enter a three- to four-digit extension number that is not is use by other
extension.
•
If the device is a fax machine, disable echo cancelling. On the FXS N page,
Audio Configuration section, set the FAX Disable ECAN field to yes. Also make
sure that the Preferred Codec is set to G.711u (default setting).
Enter the Dial Plan settings, as needed. See
Click Submit All Changes.
Chapter 6, "Configuring Music on Hold."
N
, where N is the port number.
"Configuring Dial Plans," on page
4
66.
57