Lan Setup Page And Application Page - Cisco SPA-841 - Sipura VoIP Phone Administration Manual

SPA9000 Field Reference
Router Tab
NOTE
SPA9000 Voice System Administration Guide
Router tab > Wan Setup page >
QOS Settings section
QoS Policy
QOS QDisc
Maximum Uplink Speed
Router tab > Wan Setup page >
VLAN Settings section
Enable VLAN
VLAN ID
Router tab >

Lan Setup page and Application page

Linksys Engineering and Quality Assurance strongly advise against using the
SPA9000 as a router. For this reason, the Lan Setup and Application tabs should not
be modified from the default, unused state. The SPA9000 must only be connected
to a switch via the SPA9000 INTERNET RJ45 connector. Do not connect any cable
to the SPA9000 ETHERNET port, or you may experience degraded audio
performance.
The queueing discipline, set to none or token bucket filter
(TBF). TBF limits the rate of transmission to not attempt to
exceed the Maximum Uplink Speed.
Allow QoS Queuing. Options are None or TBF (token
bucket filter). Information can be found at about TBF at:
lartc.org/howto/lartc.qdisc.classless.html
Define this value to allow the token bucket filter queueing
discipline to manage traffic flow to ensure high quality voice
audio.
Enable voice data to be tagged with the defined VLAN ID.
NOTE Choose yes If your SPA9000 is connected to a switch
that uses VLAN tagging.
The VLAN tag for the VLAN to which the SPA9000 is
assigned
B
196