Setting Up The Wan Connection For The Spa9000; Setting The Date And Time - Cisco SPA-841 - Sipura VoIP Phone Administration Manual

Basic Administration of the SPA9000
Configuring Basic Settings
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
SPA9000 Voice System Administration Guide
•
"Configuring Multicast Addressing and Group Paging," on page 33
•
"Collecting System Logs and Debug Information," on page 36

Setting Up the WAN Connection for the SPA9000

The SPA9000 becomes a DHCP client of any server on the network. The
recommended setting is to use a static IP address. This configuration provides
ease of installation and prevents connectivity issues that would occur if the IP
address of the SPA9000 changed.
Connect to the SPA9000 administration web server, and choose Admin access
with Advanced settings. (See
Server," on page 27.)
Click Router tab > Wan Setup.
Connection Type
From the
Static IP Settings
In the
NetMask Gateway
and
Optional Settings
In the
It is recommended to set an IP address that is outside the address range
NOTE
assigned by the DHCP server. For example, if the DHCP server assigns IP
addresses in the range from 192. 1 68. 1 .50 to 192. 1 68. 1 .254, you should select
a static IP address between 192. 1 68. 1 .2 and 192. 1 68. 1 .49.
Click Submit All Changes. The SPA9000 reboots.

Setting the Date and Time

The date and time appear on the phone display and are used to activate the
daytime and nighttime Auto Attendant settings. Normally the date and time are set
by the network, which has a connection to an NTP server. If needed, you can
identify the NTP server on the Voice > Wan Setup page, Optional Settings
section.
"Connecting to the SPA9000 Administration Web
drop-down list, choose Static IP.
area, enter the Static IP of the SPA9000, as well as the
for your network.
area, enter the Primary DNS for your network.
2
30