Ring And Call Waiting Tone Spec Section - Cisco SPA-841 - Sipura VoIP Phone Administration Manual

SPA9000 Field Reference
Voice tab
SPA9000 Voice System Administration Guide
Voice tab > Regional page

Ring and Call Waiting Tone Spec section

Ring Waveform
Ring Frequency
Ring Voltage
CWT Frequency
Voice tab > Regional page
Control Timer Values (sec) section
Hook Flash Timer Min
Hook Flash Timer Max
Callee On Hook Delay
Reorder Delay
Call Back Expires
Waveform for the ringing signal: Sinusoid or Trapezoid.
Default: Trapezoid
Frequency of the ringing signal. Valid values are 10–100 (Hz).
Default: 0
Ringing voltage. 60–90 (V).
Default: 85
Frequency script of the call waiting tone. All distinctive CWTs
are based on this tone.
Default: 440@-10
Minimum on-hook time before off-hook qualifies as hook-
flash. Less than this the on-hook event is ignored. Range: 0. 1 –
0.4 seconds.
Default: .1
Maximum on-hook time before off-hook qualifies as hook-
flash. More than this the on-hook event is treated as on-hook
(no hook-flash event). Range: 0.4–1.6 seconds.
Default: .9
Phone must be on-hook for at this time in sec before the
SPA9000 tears down the current inbound call. It does not
apply to outbound calls. Range: 0–255 seconds.
Default: 0
Delay after far end hangs up before reorder tone is played. 0
= plays immediately, inf = never plays. Range: 0–255
seconds.
Default: 5
Expiration time in seconds of a call back activation. Range: 0–
65535 seconds.
Default: 1800
B
229