Connecting To The Spa400 Administration Web Server - Cisco SPA-841 - Sipura VoIP Phone Administration Manual

Administering the SPA400 and Voice Mail Service

Connecting to the SPA400 Administration Web Server

Connecting to the SPA400 Administration Web Server
NOTE
STEP 1
STEP 2
SPA9000 Voice System Administration Guide
You can manage a SPA400 by using the web-based configuration utility.
If you have not already done so, connect the SPA400 to the same switch as the
SPA9000 and the SPA900 series IP phones. For more information, see the SPA400
Quick Install Guide.
Start Internet Explorer, and enter the IP address of the SPA400 that you want to
configure.
By default, the SPA400 is configured to obtain an IP Address via DHCP. You
NOTE
can check the obtained IP address on the router DHCP server's client list.
When the password prompt appears, enter the default user name, Admin, with no
password. Then click OK.
The user name must be entered exactly as shown: Admin. By default, no
NOTE
password is required, but a password can be set on the Administration >
Management page. See
Configuration Utility," on
"Managing Access to the SPA400 Web-Based
page106.
5
103