Pittway NOTIFIER The SYSTEM 5000 Installation Manual page 81

Step 1:
Insert the CPU into the left-most cabinet slot, angling
the front end of the module into position as shown.
Cabinet
Step 3:
Align the module screws with the thread-holes on the chassis and secure in place.
Step 1:
Angle the module into the chassis so that the upper
board edge slips into the chassis slot as shown.
Figure A-4: Mounting Modules in the Backbox
Figure A-3: Mounting the CPU
S5000 15583 Rev.
Step 2:
Push the back end of the module down into the cabinet
and pull down until the upper board engages the slot on
the chassis as shown.
Cabinet
Step 2:
Push the upper end of the module into the chassis
and secure with two module screws.
6/10/96 P/N 15583:
81