Tripod Data Systems CO-OP 41 User Manual page 79

Remarks: This function only applies to such functions as
NORTH, SOUTH, etc.. Functions such as LINES and ALC
control the pen being in the up and down position, and
will always draw on the plat.
PRINT CALLS
Name: Print Calls
Purpose: Print out the calls of the points in the Random
Pointfile, in a tabular format at the current pen position.
Keystrokes: [SHIFT] [PRINT CALLS]
Entry Conditions: Must have the points to print the calls
on in the Random Pointfile.
Operation: When executed the CO-OP 41 will prompt for
what size of letters to print the calls with.
[LETTER SIZE?
When you enter this the CO-OP 41 will print out the calls
of the points in the Random Point file at the current pen
position. The will be in the following format
1-2 N 0 00' 00" E 100.00
Where 1-2 means that the call is for the line going from
point 1 to point 2. N 0 00' 00" E means that the line lies
in the N-E quadrant at an angle of 0 degrees 00 minutes 00
seconds. 100.00 is the distance between points 1 and 2 (in
this case 100.00 feet). If more then one call is to be printed
they will be printed one below the other.
Remarks: If the text direction has been changes (by TEXT
DIRECTION function) then the calls will be printed at the
Plotter Module User's Manual 71