Tripod Data Systems CO-OP 41 User Manual page 75

will bring up a scroll menu allowing for the selection of
whetherletters are to be printed at a slant, or with no
slant.
After this the CO-OP 41 will prompt for the letter size to
use when plotting the point numbers (and elevation
and/or note depending on the system used).
[LETTER SIZE? |
You can either key in a letter size or press for the
default letter size of 12. After this is keyed in the CO-OP 41
prompts for the scale factor to use on the drawing.
[SCALE?
You can either key in a new scale factor or press to
use the default of 1" to 100'. Once you key in both of these
values the CO-OP 41 will prompt for the type of point
marker to be used.
Uses a closed point. [DOT MARKER " |
Uses an open point. [CIR MARKER " |
Next the CO-OP 41 will prompt for the lowest north
coordinate that will position your job on the plotting
sheet.
[LOW NORTH? |
You mayeither key in a the lowest north coordinate (the
north coordinate for the southwest corner of your plat), or
you may press and have the CO-OP 41 automatically
do a search and find the low north, and low east
coordinates. If you answer the LOW NORTH prompt, the
CO-OP 41 will prompt for the lowest east coordinate.
[LOW EAST?
Plotter Module User's Manual 67