Tripod Data Systems CO-OP 41 User Manual page 66

assigning the keys the CO-OP 41 will prompt for the pen to
use during plotting.
[PEN NO.
If you have a single pen plotter then ignore this prompt
and press [R/S], otherwise key in the pen number that you
want to use for this plotting session. Next, the CO-OP 41
will bring up a scroll menu allowing for the selection of
whether letters are to be printed at a slant, or with no
slant.
Next the CO-OP 41 will promptfor the letter size to use
when plotting the point numbers (and elevation and/or
note depending on the system used).
[LETTER SIZE? |
You can either key in a letter size or press for the
default letter size of 12. After this is keyed in the CO-OP 41
prompts for the scale factor to use on the drawing.
[SCALE?
You can either key in a new scale factor or press to
use the default of 1" to 100". Once you key in both of these
values the CO-OP 41 will prompt for the type of point
marker to be used.
Next the CO-OP 41 will prompt for the lowest north
coordinate that will position your job on the plotting
sheet.
58 CO-OP 41 Data Collector