Tripod Data Systems CO-OP 41 User Manual page 53

OUT B/D ~~ Will print both the bearing and the distance
on the outside of the line. Note that this will not do spur
azimuth's, and should only be used for long boundary
lines.
INSIDE DIST" Prints the distance on the inside of the
lines, does not print the bearing.
OUT DIST ~~ Prints the distance on the outside of the
lines, does not print the bearing.
See Also: SPUR, OPT
CONTOUR
Name: Contour
Purpose: Plots contour tick marks at a specified interval
on the plat, between points at different elevations.
Keystrokes: [SHIFT] [CONTOUR]
Entry Conditions: Must be in a job file with elevation
stored with the points. Must also store the contour points
in the random pointfile by using the RPC function.
Operation: When executed the CO-OP 41 prompts for the
interval at which to plot the contour tick marks on the
plat.
[CONT INT?
After you enter this the CO-OP 41 will calculate the
number of tick marks needed between the coordinate
pairs given in the random pointfile and plot the ticks
accordingly.
Plotter Module User's Manual 45