Tripod Data Systems CO-OP 41 User Manual page 15

1 [TO PT?
3 (R/S)
If everything is working correctly, the plotter should put a
dot on the plat for each of the three points, and print the
point number beside each point. If this didn't work, then
follow the steps below.
1. Make certain the plotter is properly connected to
the CO-OP 41. Check the instructions above and
the plotter manual.
2. Execute the plotter initialization function again.
3. Try the triangle plot again. If it still doesn't work,
then call your local dealer.
Plotter Module User's Manual 7