Rap 18 Document Skews - OKIDATA OF2600 Service Manual

RAP 18 Document Skews

START
Are the document guides set to meet the document width? Are the documents properly loaded along the
guides?
NO Set the guides to meet the document width. Load the documents properly along the guides.
YES Are all of the documents the same width?
NO Load ONLY documents of the same width.
YES Check the thickness of the document(s). Is the thickness within specifications?
Multiple documents: 0.06 to 0.13 mm
Single documents: 0.05 to 0.15 mm
Is the control panel unit closed firmly?
NO Close the control panel unit firmly.
YES Is the paper path obstructed?
YES Remove the obstructions.
NO Is the separation rubber dirty?
YES Clean it with water.
NO Press on the pinch rollers. When released, do they return to their
normal positions?
Service Guide OF2200/2400/2600
NO Use documents of the proper specification.
YES Are the documents normal?
NO Use a carrier sheet.
YES Check for the following:
Adhesive (paste, tape) on the surface of the documents.
The leading edge(s) of the document(s) are uneven.
Chapter 2 Failure Analysis
Page: 66