RAP 21H Poor Fusing
NOTE:
If the fusing unit is not functioning, the message PRINTER ALARM 4 will be displayed on the LCD. Refer
to RAP 20E.
Use RAP 21H when printed output smears when touched.
START
Is the paper used designed for use in xerographic printers?
NO Use paper designed for use in xerographic paper.
YES Are the springs for the pressure roller functioning properly? Do they compress when pushed?
NO Replace the springs.
YES Replace the printer control board.
Has the problem been resolved?
YES End of procedure.
NO Replace the power supply board.
Has the problem been resolved?
YES End of procedure.
NO Replace the fuser assembly.
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)
Service Guide OF2200/2400/2600
Chapter 2 Failure Analysis
Page: 85