RAP 16 Document Does Not Feed
START
Place document(s) on the ADF tray.
Does the ADF roller rotate?
NO Check that the scan motor is properly connected to CN8 of the printer control board.
Is the problem resolved?
YES End of procedure.
NO Does PC1 function properly?.
NO Replace PC1
YES Replace the following in the listed order.
YES Is the control panel unit properly closed?
NO Properly close the control panel unit.
YES Is the leading edge of document curled or folded?
YES Load a document that is not curled or folded.
NO Verify that there are not too many documents loaded. Verify that the
paper thickness does not exceed 0.15 mm.
Do the documents meet the above criteria?
NO Use documents that meet the above criteria.
YES Are the paper paths of the scanning route blocked?
YES Clear the scanning route.
NO Replace the following in the order listed.
Service Guide OF2200/2400/2600
(Refer to RAP 04)
1. Printer Control Board
2. Scan Motor
(1) ADF Roller, (2) Sub-Roller, (3) Separation Rubber
Chapter 2 Failure Analysis
Page: 64