Extron electronics ShareLink Pro 2500 User Manual page 84

Command
Force user to stop sharing
Force disconnect user
Swap positions of two streams
Show a shared content in full
screen
Revert full screen content
Query full screen state
Approve user connection
request (moderator mode only)
Reject user connection request
(moderator mode only)
Approve user share request
(moderator mode only)
Reject user share request
(moderator mode only)
SIS-over-SSH
NOTES:
• The echo setting must match the type of SSH client used.
typed into the client window (such as PuTTY) are echoed in the window along with the SIS response, and
are also sent to the server.
• With echo disabled, the characters are not echoed but are simply sent to the server.
• The echo setting applies only to current (not global) connection.
• Control systems should turn echo off after connecting.
Enable echo (default)
Disable echo
View echo status
Set current port timeout
View current port timeout
Set global port timeout
View global port timeout
KEY:
X6@ 1 (= 10 seconds) to 65000 (650,000 seconds)
= Port
(Default is 30 = 300 seconds = 5 minutes)
timeout:
X7%
= Echo status: 0 = disabled, 1 = enabled (default)
ASCII Command Response
(Host to Device) (Device to Host)
E X6$ }
S SHAR SharS
E X6$ }
D SHAR SharD
E X6$ X6$ }
W * SHAR SharW
E X6$ }
F *1SHAR SharF
E }
F0SHAR SharF0
E } X7^]
FSHAR
SharF
E X6$ }
C *1SHAR SharC
E X6$ }
C *0SHAR SharC
E X6$ }
R *1SHAR SharR
E X6$ }
R *0SHAR SharR
E }
1ECHO Echo1
E }
0ECHO Echo0
E } X7%]
ECHO
E X6@ }
0* TC Pti0*
E } X6@]
0TC
Pti0*
E X6@ }
1* TC Pti1*
E } X6@]
1TC
ShareLink Pro 2500 • SIS Configuration and Control
Additional Description
Force user
X6$]
content. If
X6$] Force disconnection of user
If = , disconnect all
X6$
0
X6$ X6$]
*
X6$ ]
*1
Revert full screen content back to
]
quadrant view
View full screen state
(Verbose mode 2/3)
X6$ X7^]
*
If = , return response is
X7^
0
Approve user request to connect
X6$ ]
*1
Reject user request to connect
X6$ ]
*0
Approve user request to share
X6$ ]
*1
content
Reject user request to share content
X6$ ]
*0
With echo enabled (default), characters that are
Echo on: All data sent is echoed
]
back to the sender, followed by the
response.
Extra carriage returns may also be
received when echo is on.
Echo off: only the response is sent to
]
the sender.
View the echo setting
X6@]
X6@] (Verbose mode 2/3)
X6@]
X6$
= Connection ID (10 digits)
X7^
= Full screen state: 0 = disabled, 1 = enabled
to stop sharing
X6$
= , stop sharing all.
X6$
0
X6$ .
X7^]
76