Extron electronics ShareLink Pro 2500 User Manual page 63

NOTES:
• Performance also depends on the quality of the Windows 10 hardware, the wireless environment,
and the overall performance of the Wi‑Fi network. The strength of the wireless signal could have
an adverse impact on connection quality and potentially cause considerable packet loss. Low
signal strengths may prevent connections between Windows 10 client devices and the ShareLink
Pro. Even if a connection is established, low signal strengths may cause low frame rate, high
latency, poor audio and/or video quality, and dropped connections.
• To improve end user experience, the following is recommended:
Ensure that the enterprise wireless access points serving the Wi‑Fi network maintain high
•
signal strengths and are configured to operate on Wi‑Fi channels with the least interference
(ideally unoccupied and non‑overlapping channels).
Ensure that the WFA 100 attached to ShareLink Pro devices are also configured (via PCS) to
•
operate on Wi‑Fi channels with the least interference (ideally unoccupied and non‑overlapping
channels). For WFA 100 channel configuration instructions, see the next
Perform a scan of the environment using wireless survey equipment that is regularly
•
calibrated, and make note of areas with low or no wireless coverage on a map. Introduce
wireless coverage where needed as necessary by adjusting physical access point locations,
channel selections, and channel bandwidths. Access point power levels may also require
tweaking for optimal performance.
Configure quality‑of‑service on networking equipment (switches, routers, wireless LAN
•
controllers, etc.) to prioritize Miracast traffic. Miracast packets are marked as CS5 with DSCP
Value = 101 000 and Decimal Value = 40.
Minimize the number of network hops between the wireless access point and the ShareLink
•
Pro device.
Refer to the Miracast Setup Guide available on the Extron website for more network design
•
considerations.
ShareLink Pro 2500 • Other Configuration Options
page.
55