Labconco Protector 50600 User Manual page 15

C h a p t e r 3
C h a p t e r 3
G e t t i n g S
G e t t i n g S
Once the site for your glove box is properly prepared, you are ready to unpack,
inspect, install, and validate performance of your system. Read this chapter to
learn how to:
 Unpack and move the glove box.
 Set up the glove box with the proper supporting structure and work surface.
 Add the oil and if required connect an exhaust system to the pressure relief
bubbler.
 Install the gloves.
 Connect the electrical supply.
 Connect the plumbing lines for gas, vacuum, and gas purifiers or drying
trains.
 Validate performance of the glove box.
Each Protector Glove Box model weighs as follows:
!
 Fiberglass, 350 lbs/157 kg.
 Stainless, 500 lbs/225 kg.
 Stainless Doublewide, 1000 lbs/450 kg.
The shipping container allows for lifting with a mechanical lift
truck or floor jack. If you must lift the glove box manually,
follow safe-lifting guidelines. Do not lift by the upper sheet
metal façade and front panel as damage can occur to the glove
box liner.
Product Service 1-800-522-7658
:
:
t a r t e d
t a r t e d
11