Replace Spark Plug; (Inspections Ii And Iii) - BMW C1 200 Repair Manual

L
Note:
Always renew the screw plug's sealing ring!
•
Install chain tensioner (
e
Attention:
Remove TDC set bolt, BMW No. 11 7 651.
•
Turn the engine over several times by hand
•
Check valve clearance and adjust as necessary
L
Note:
Install cover seal, ensuring that it and groove in cyl-
inder head cover are free of oil!
•
Install the cylinder head cover before installing
the powertrain cradle
e
Attention:
When lowering note the positions of the spring
struts!
L
Note:
Make sure the long lever of the easy-lift mechanism
engages. If necessary, move the lever to the drive
position first, and then move it to the park position!
Fluids and lubricants:
Guide rail............................................... Loctite 243
Camshaft sprocket ................................ Loctite 243
X
Torque specification:
Guide rail attachment ................................... 10 Nm
Camshaft sprockets .................................... 30 Nm
Camshaft bearing cap bolt ........................... 10 Nm
TDC bolt socket plug ................................... 15 Nm
Chain tensioner plug .................................... 35 Nm
Lower strut mount ........................................ 21 Nm
00.42
11.33)
a

Replace spark plug

(Inspections II and III)

– Remove left service cover
12 3 531
•
Disconnect spark plug cap
•
Use spark-plug wrench, BMW No. 12 3 531, to
remove spark plug
X
Torque specification:
Spark plugs.................................................. 15 Nm
Fluids and lubricants:
Spark plug .........................................NGK CR 8EB
C1120030