Replace Seal Telescopic Tube/Seal Holder; Remove Seal Holder; Install Seal Holder - BMW C1 200 Repair Manual

Replace seal telescopic tube/seal
holder

Remove seal holder

e
Attention:
Do not scrape the telescoping tube – mask it off if
necessary!
– Remove telescopic tube cross brace with tele-
scopic tubes ( 31.11)
a
•
Remove front wheel
– Remove telescopic tube seal (
4
e
Attention:
Washer (4) must be removed!
•
Remove washer (4)
00 8 400
31 5 711
•
Remove seal holder (arrow) with puller
BMW No. 00 8 400 and support
BMW No. 31 5 711
31.14

Install seal holder

•
While installation is basically a reversal of the re-
moval process, careful attention should be di-
rected toward the following:
e
Never install anything other than new seal holder
and new gaskets/seals!
Take care to avoid tilting seal holder during installa-
tion!
31.13)
a
•
Place telescopic fork on a firm support surface
C1310160
•
Use drift punch, BMW No. 31 5 712, to mount
and seat new seal holder
– Installing telescopic tube seal (
•
Install front wheel
– Install telescopic tube cross brace with telescop-
ic tubes (
C1310260
Attention:
31 5 712
31.18)
a
C1310300
31.13)
a