Brake line between brake hose, left
brake-control assembly, and brake
hose to brake caliper - without ABS
–
Remove instrument trim
–
Remove knee pad
–
Remove top and right tunnel panels
–
Remove right service cover
....................................................See Group 46
a
–
Drain the rear brake circuit
e
Attention:
Do not allow brake fluid to come into contact with
painted parts of the motorcycle - brake fluid attacks
paint! Wrap clean shop towels around open pres-
sure lines to prevent residual brake fluid from escap-
ing!
•
Disconnect brake line at union (1, 2)
•
Remove brake hose brackets by extracting up-
ward
•
Remove fasteners (arrows) securing brake line
•
Remove brake line
34.24
1
2
When installing:
•
While installation is basically a reversal of the re-
moval process, careful attention should be di-
rected toward the following:
e
Attention:
Make sure that all lines and the Bowden cables are
correctly routed and that cables will not be subject
to rubbing and abrasion!
–
Fill and bleed the brake system
X
Torque specifications:
Brake hose/line joint..................................... 18 Nm
Brake line to frame ......................................... 5 Nm
C1340281