BMW C1 200 Repair Manual page 283

Replacing rear ABS reluctor
34 51 109
– Remove rear wheel
....................................................See Group 36
a
•
Remove 5 fasteners (arrows) securing the ABS
reluctor
•
Remove the ABS reluctor
When installing:
•
While installation is basically a reversal of the re-
moval process, careful attention should be di-
rected toward the following:
•
Check the ABS sensor gap and adjust if neces-
sary
X
Torque specification:
ABS reluctor attachment ................................ 5 Nm
Checking and adjusting ABS wheel-
speed sensor gap
Front wheel
36 30 300
e
Attention:
Check ABS wheelspeed sensor gap when ABS sen-
sor, reluctor, wheel bearing, front wheel, floating
axle shim or telescopic fork is replaced!
C1340060
1
•
Use feeler gauge to check gap between ABS
wheelspeed sensor (2) and reluctor (1) at three
points at120° intervals (arrow), adjust with shims
as necessary
Adjustment data:
ABS sensor gap ..................min 0.3 mm (0.0118 in)
2
C1340130
34.15