Replacing spring/shock absorber
–
Removing strut (
31.19)
a
d
Warning:
The spring strut is spring-loaded: proceed carefully
when disassembling - injury hazard!
3
33 5 600
•
Compress spring with
device (3) BMW No. 33 5 600,
adapter (2), BMW No. 31 5 540,
adapter (1), BMW No. 33 5 606
•
Remove retaining plate (arrow)
•
Release and remove spring
When installing:
•
While installation is basically a reversal of the re-
moval process, careful attention should be di-
rected toward the following:
•
Install end of spring opposite the slot in the re-
taining plate, ensuring that the entire surface of
the end of the spring rests securely against the
retaining plate
•
Check to verify that spring is installed correctly
31 42 405
1
leading link
33 5 606
Removing leading link
–
Remove upper left and right tunnel panels
....................................................See Group 46
a
2
31 6 540
C1310390
00 1 570
•
Raise vehicle wirth hoist, BMW No. 00 1 570
•
Lower the front wheel (move the large lever of the
easy-lift mechanism down)
C1330010
•
Disconnect spring strut from leading link
Removing and installing
C1310000
C1310200
31.23