Checking The Brake Discs - BMW C1 200 Repair Manual

•
Remove support plate (1) to the inside
When installing:
•
While installation is basically a reversal of the re-
moval process, careful attention should be di-
rected toward the following operations:
e
Attention:
Always replace the backplate!
Ensure that the backplate seats correctly!
Take care to avoid damaging brake pads when in-
stalling!
•
Install new backplate
•
Use a long-nosed punch to install the dowel pin
•
Check the operation of the brake system
e
Attention:
The fluid level in the brake fluid reservoir must be at
the "MAX" mark after the brake pads have been
changed. It is not possible to determine whether the
brake fluid is at the specified maximum level through
the sight glass. For details on the correct procedure
see Checking fluid level in the open brake fluid
reservoir!
1
C1340480

Checking the brake discs

•
Carefully check the brake discs for cracking,
damage, deformation and scoring
•
Measure the thickness of the brake discs at sev-
eral points with a caliper gauge
Wear data:
Front brake discs ..................... 4.0 mm/0.15748 in
Rear brake disc........................ 4.0 mm/0.15748 in
C1340420
00.49