Gearbox Cover Removal; Gearbox Shaft Removal - BMW C1 200 Repair Manual

# Gearbox cover removal

11 11 018
– Remove complete variator assembly
– Drain oil from gearbox
•
Open drain plug (arrow)
•
Remove securing screws
•
Install two M6x70 screws in threaded sockets
(arrows) and pull off cover
•
Use screwdriver to pry out shaft oil seal
L
Note:
Remove variator shaft complete with cover!
•
Check joint surface for damage
•
Check condition of cylindrical rollers
•
Check bearings for discolouration
24.20

# Gearbox shaft removal

L
Note:
Additional work necessary if powertrain cradle is to
remain installed:
- Remove rear wheel (
- Use strut support
– Remove gearbox cover
C110690
•
Remove thrust washer (arrow) from intermediate
shaft
•
Remove seal
•
Tap output shaft lightly with plastic-headed ham-
mer to release it from interference-fit in grooved
ball bearing and shaft oil seal
•
Remove intermediate shaft and thrust washer
beneath it
C1110700
36.9)
a
C1110710