BMW C1 200 Repair Manual page 354

•
Detach stand Bowden cable (arrow) from cable
pulley and extract from the pulley by pulling at an
angle
•
Remove Bowden cable from articulated-lever
mechanism
•
Remove fasteners (arrows) from articulated-lever
mechanism on right
•
Lift up articulated-lever mechanism to remove
46.36
When installing:
•
Installation is the reverse of the removal proce-
dure: Pay particular attention to the following:
e
Attention:
Install the eyebolts (bottom anchors for springs) with
the eyes parallel to the vehicle's front-to-rear axis.
Do not mix up left and right-side springs!
Make sure that the Bowden cables for extending/re-
tracting stand, seat-belt central release and throttle
actuation are correctly routed.
Bowden cables on cable pulley - align stand cor-
rectly!
Make sure the hoses will not rub und wear during
operation!
C1460510
Adjustment data:
Take up all play at the Bowden cables so that the
stand is held in its limit positions by the springs
X
Torque specification:
Strut attachment .......................................... 41 Nm
Eye bolt attachment ....................................... 8 Nm
Articulated joint mechanism attachment....... 21 Nm
Bowden cable locknuts .................................. 8 Nm
C1460520