BMW C1 200 Repair Manual page 165

10
9
Replacing coolant hoses on engine
– Open the seat
....................................................See Group 52
a
– Remove left service cover
....................................................See Group 46
a
– Drain coolant ( 17.14)
a
Remove engine coolant hoses
•
Open hose clamps (1, 9, 10)
•
Slacken screw clamp (5)
•
Release starter cable bracket (2) from custom-
moulded hose
•
Disconnect spark plug cap
•
Remove ignition cable bracket (7)
•
Detach bracket (6) for seat-belt central release
cable from moulded hose
•
Release moulded hose from bracket (8)
•
Remove all coolant hoses from engine
17 12 190 Replacing coolant hoses
– Removing engine coolant hoses
•
Remove the appropriate moulded hose
1
8
7
11 53 120 Replacing thermostat
– Remove engine coolant hoses
•
Remove thermostat (4)
Install engine coolant hoses
•
Installation is the reverse of the removal proce-
dure
e
Attention:
Always make sure that hose clamps (1, 9, 10) are
correctly positioned in order to ensure easy access
whenever necessary.
Make sure the hoses are routed well away from any
components that could cause rubbing and abrasion!
•
Adding coolant
•
After running the engine check the coolant level
and top up if necessary!
X
Torque specification:
Screw clamp to engine ...........................hand-tight
4
6
5
2
4
3
C1170070
17.9